5 Tier White Round Maypole Cupcake Stand

5 Tier White Maypole Cupcake Stand by Cheerico, including 4 acrylic feet.

The edges of the acrylic cupcake stand are perfectly clear and polished.

Every part of the stand has been accurately cut and finished, hence there is no need for glue or other fixings.

Cheerico Cupcake Stand has been specially designed so it can be taken apart, washed and stored away for another time.
The stand comes flat packed and only takes a few minutes to assemble.
# Each tier is 100mm apart and the total height of the stand is 430mm.
# The acrylic comes wrapped in the manufactures protective covering
# 1st,2nd,3rd,4th, 5th tier is 5mm thick . 

The entire size:  Length 350 * Width 350 * Height 430mm

Rod Size : Diameter 25mm x Height 100mm

Tier 1: Dia 150mm
Tier 2: Dia 200mm
Tier 3: Dia 250mm
Tier 4: Dia 300mm
Tier 5: Dia 350mm  

This white Cheerico cupcake stand can hold approximately 60 cupcakes.
We base our numbers on using a 60mm diameter cupcake. The four small round plastic feet are included so you can use any tier as bottom tier. This stand is unique from other sellers as the tiers are specially designed so you can use any plate as bottom tier.

Below you will find an example of how many cupcakes can be arranged on each tier. 

PLEASE NOTE: You must remove the manufacturers’ protective cover before assembling this product. This covering is clear bubble and cling wrap on both sides of every acrylic component.

Download Assembly instructions for Round Maypole cupcake Stand

ASSEMBLY GUIDE for CHEERICO White Cupcake Stand :

Parts: Acrylic discs, head screws, double screws, acrylic rods and acrylic feet.

* Remove the manufacturer’s protective cover from BOTH side of each acrylic component.
* Begin by placing the feet to the underside of the bottom disc ensuring they are evenly spaced.
* Take a metal head screw and place it on to a flat surface where the stand is to be constructed
* Carefully line up the hole(s) of the largest disk with head screw ensuring the disc is resting securely on the acrylic feet.
* Now screw the first rod onto the screw thread of the head screw making sure the acrylic disc is clamped firmly between two components.
* Continue by placing the next largest disc on to the screw thread of rod and tighten each piece as you go.
* The final rod is to be used as the supposed for the top tier and the stand is completed by adding the other screw cap into the top.

CARE GUIDE:

* The stand is made from acrylic which will scratch if it is not looked after properly. 
* To clean the product use warm water with a little washing-up liquid and soft cloth. 
* Do not use any abrasive cleaning products as they will make the acrylic. 
* Do not put the stand in a dishwater